Currently there are only the built-in patches to choose from, but the current patch can be imported and exported as a MIDI SysEx message. This is the only view you need, if you don’t plan to make own custom instruments. ![]() Each view has up to four parameters that can be adjusted using the four up and down arrows in the middle.īROWSE view: Browse the preset patches, export current patch and set MIDI channel. The four buttons at lower left and lower right corners are used to switch between different views. Because the synth can only play 4 notes simultaneusly, you might need to manually add small gaps between adjacent notes. Note that MIDI events that happen at the same time are not sent in any particular order, so a note-on message (for next note) might be sent before a note-off (for previous note). You can also play MIDI tracks on a music software and configure it to send MIDI messages to Pokitto. To use a MIDI keyboard, connect it to the computer and route MIDI messges from the keyboard to Pokitto. MIDI channel on the synth defaults to 1 and can be changed from BROWSE view. It should only take a second or two to establish the connection. USB MIDI connectionįor USB MIDI you need to have Pokitto connected to the computer when the synth starts, and press C when asked to enable USB. You can use this feature to play instruments that have glide enabled, or alternatively use sustain for that. You can move left or right on the keyboard also while holding B, in which case the note keeps playing until you stop at another key and a new note is triggered. Pressing B at any time plays a note, even when the virtual keyboard is hidden.
0 Comments
Leave a Reply. |